# FABRICATION ###### tags: `WORK STATION FOR ARTIST` 12/12 First Assemble in the Lab ![](https://i.imgur.com/BErS0ev.jpg) ![](https://i.imgur.com/wRgY1cH.jpg) ![](https://i.imgur.com/zsQbw7g.jpg) 09/12 First Farbrication & Assemble ![](https://i.imgur.com/UTAz79D.jpg) 08/12 Sktech ![](https://i.imgur.com/AP3Z7Uq.png) 24/11 3D Sketch **Unit: mm** L: 830, W: 530, H: 580 ![](https://i.imgur.com/llPdKDc.png) ![](https://i.imgur.com/rzDwYlY.png) ![](https://i.imgur.com/MpvUhcZ.png) 23/11 3D Sketch These are the concept about how to place the sensors inside the box and also prevent the bugs escape. The outside frames could fix with some acrylic plate on each side to avoid outside noise directly transparent into the box. ![](https://i.imgur.com/CLbwIaC.png) We could place the sensor box on either top or bottom. The size of the "Sensor box" is dependent on all the sensor's dimension. The electronic wire could be passing through the center of the holder rod. ![](https://i.imgur.com/YUjw4qv.png) ![](https://i.imgur.com/RHwZ9M3.png) ![](https://i.imgur.com/79kpN98.png) The multi-layer design let this box is ventilation. 18/11 jonthan's 3D sketch ![](https://i.imgur.com/TGLczNt.jpg)