J4078-02-04X–-Easy description.docx (中翻英)

“The command systax is “phyzone phy_index group”.” ，

此指令只能指定 PHY ID 對應到所需設定的 group。

This command set the group of PHY ID.

因應不同機種及背板 PHY ID 並不與 JBOD slot 對應；

Please note that JBOD slot number is not PHY ID number.

與 JBOD slot 對應的是 CONN ELEM INDEX (且 CONN TYPE=0x20)。

The JBOD slot number is same as CONN ELEM INDEX (hexadecimal) number.

JBOD slot 1 (10進制)< = > CONN ELEM INDEX 0x01(16進制)< = > PHY ID(10進制)

We can find corresponding with those item.

JBOD slot(Decimal) <=> CONN ELEM INDEX(hexadecimal) <=> PHY ID(Decimal)


JBOD slot: "1" <=> CONN ELEM INDEX: "0x01" <=> PHY ID: "29"

Edge-0 Phy ID與JBOD Slot 詳細對照表，JBOD Slot refer P40

Edge0: JBOD slot & PHY ID comparison table.

舉例來說，如果要將 JBOD slot 1-4 設定成 group 8。

For the example is
Assign the JBOD slot 1,2,3,4 drive on PHY29,PHY30,PHY31,PHY00 of EDGE to the Group8.

cmd>phyzone 29 08
cmd>phyzone 30 08
cmd>phyzone 31 08
cmd>phyzone 00 08

接著找出相對應的wide port並設定，

解釋原理說明 --- 不翻譯

因應不同機種及背板對應的 PHY ID 組 (4個)，

Please note that 1 JBOD Wideport with 4 PHY ID number.

接上 SAS HD Cable 會出現 HBA Card 的 SAS Adders ，就會知道 Wide Port 的對應PHY ID。示意圖如下

解釋原理說明 --- 不翻譯

Hub Phy ID與JBOD wide port 對照表

HUB Phy ID與JBOD wide port 對照表

HUB: JBOD Wideport & PHY ID comparison table.

請連接至相對應的Wide Port 並做設定

解釋原理說明 --- 不翻譯

舉例來說

連接至Wide Port 1

For the example is
Assign the Wideport1 (PHY12 - PHY15) of HUB for Group8

cmd>phyzone 12 08
cmd>phyzone 13 08
cmd>phyzone 14 08
cmd>phyzone 15 08

因此Wide Port 1可以看到 JBOD Slot設定為08的群組

解釋原理說明 --- 不翻譯

Edge 及Wide Port需同時設定完成，才可使用，且EXP PRI & SEC 都需要設定

Please note if you are Dual EXP JBOD, PRI(HUB & EDGE) and SEC(HUB & EDGE) should be applied with the same configuration.

設定完成 T10 zoning 後，需要 power cycle JBOD，讓 EXP PRI & SEC 同時生效。


Power cycle whole JBOD for taking effect with the new settings.
.
Select a repo