# Custom Amhara (JH) ## Updates / changes discussed with Azo - Leaving out 1060D ballistic bottom - Updates to DNC highlights (details below) ## Volume - 28L (main compartment capacity excluding side pockets and front panel) ## Exterior design ### Front - No PALS (webbing can be bartacked) - Front compartment with double zip access - Possible to open without unbuckling straps - [Design similar to this earlier Amhara example](https://www.instagram.com/reel/C64Ssfqsqjf/?igsh=ejJtZXlqeXYwbWNs) ![front_s](https://hackmd.io/_uploads/HypsIOL-lg.png) - **Note:** The large QAP entry point should be at the back of the lid, near the carry handle ### Side - 2x bellowing 2L side pockets (same material as pack external) - Inspiration from [Savotta Kahakka 25](https://www.savotta.fi/products/kahakka-25l?srsltid=AfmBOoqoTfMVK-FV5_aPJR5uTWTTb8Eix2ryqEHUGktk4iTLYADFyaqu) - Easy-to-use SR buckle setup for compression - Savotta use G-hooks for Kahakka, but here would prefer buckles - Reinforced side gusset handles for easy handling - Kahakka side pocket looks like this: ![kahakka](https://hackmd.io/_uploads/H1eU0Qzzee.jpg) ### Lid - Removable / replaceable - Two external-facing QAPs - One larger with double zip - Other smaller with single zip - The large QAP can cover almost the entire lid, with the zip located close to the top carry handle - Reinforced carry handle (thicker webbing) ### Main compartment and laptop access - Double zipper clamshell access to main compartment - Regular Amhara style cinch access to main (under lid) - Separate zippered access to 16" laptop section on side - Clamshell and laptop access zips protected by flap ### Bottom of the pack - Reinforced bottom that wraps around entire lower part of the pack - Stiff enough to be self-standing ### External fabrics and materials - All zippers regular reverse coil (no Aquaguard or Uretek) - Plastic buckles (attached to prevent dangling when open) - All hardware used should be identical to or replaceable with [Savotta spare parts](https://www.savotta.fi/collections/repair-and-spare-parts) - Front and sides: 1000D Cordura (colour: RAL 7013) - Harness: standard Azo design (500D Cordura) - Desert Night Camo highlights (500D) under lid and in front admin panel - No Hypalon (can use webbing instead) - Webbing material: Mil-spec 17337 ## Interior design ### Front panel design - Admin section with two slip pockets and a larger sleeve for tablet or documents: ![admin2](https://hackmd.io/_uploads/ByM20Qzzxe.jpg) ### Main compartment - Padded and suspended 16" laptop section - Kydex frame sheet - Two zippered pockets on inner surface facing laptop compartment: ![inner2](https://hackmd.io/_uploads/ByLWJ4Mzlx.jpg) ### Interior fabrics - Challenge Sailcloth Ultragrid (Castlerock)