---
title: 網路實習LAB1
---

Switch:

Open CLI: Click on the switch and then click the CLI Tab
### 1. Setup privileged mode password. 10%

shown by CLI type this column into CLI

Switch> enable
Switch# configure terminal
Switch(config)# enable secret ntpu

### 2. Setup a new VLAN and add an interface to the new VLAN 20%

Switch(config)# vlan 2
Switch(config-vlan)#exit
Switch(config)# interface fa 0/2
Switch(config-if)# switchport access vlan 2
Switch(config-if)# exit

### 3. Setup VLAN with IP address 20%

Switch(config)# interface vlan 1
Switch(config-if)# ip address 192.168.4.1 255.255.255.0
Switch(config-if)# no sh //short for no shutdown
Switch(config-if)# exit

### 4. Setup port security on switch at the new Vlan 50%

Switch(config)# interface fastethernet 0/2
Switch(config-if)# switchport mode access
Switch(config-if)# switchport port-security
Switch(config-if)# switchport port-security mac-address sticky
Switch(config-if)# exit
Switch(config)# exit

### Final. Check result

Switch# sh running-config
Switch# show port-security interface fa 0/2
Switch# show vlan br

###### tags: `Computer Network Lab` `CSnote`