---
# System prepended metadata

title: Regular Meeting (2022.7.25)
tags: [Regular Meeting, DeWei]

---

# Regular Meeting (2022.7.25)

* Zybo-z7
* CDCFE Fanout Baord

## 1 Zybo-Z7

Assemble initramfs

## 2 CDCFE Fanout Baord

### 2.1 Schedule:
1. ~~Booking BOM (~2 weeks DT)~~ -> *Some component I haven't received*
	* ~~Layout completed within 2 weeks~~ -> *Somewhere I'like to discuss with you* (in the following chapter)
2. ~~Print 1:1 board, put booked compoent on board (Jenny's suggestion)~~ (ok)
	2.5 Maybe verify each IC with SMD-DIP board
3. Delivered for manufacturing (~1 weeks)
4. Soldering

### 2.2 Design:

|Last week|This week|
|--|--|
| ![](https://i.imgur.com/rsEFhgJ.png)|![](https://i.imgur.com/BZ5O1JQ.png) |

### 2.3 Last week we discussed about cable

>* Wire (fanout to prototype or fanout to scope)~10 pcs, 2 
	>>* SMA(female) to u.fl(male)
	>>* u.fl(male) to u.fl(male)
	>>
* Replace above mentioned with **Test Point PAD**
	* Refer to [Test Points in High-Speed PCB Design](https://www.youtube.com/watch?v=TzADUgKH_cE&ab_channel=AltiumAcademy)
* 8\*SMA connector, which path are awful
* Risk:
	* Additional layout pad may cause additional signal attenuation(*distortion*)
	* Probe to scope
		* Our *new* probe R/F time < 1ns
		  * Old func-240MHZ-gen: R/F time = 4.5 ns (1Vpp)
		  * New func-250MHZ-gen: R/F time = 2 ns (<5Vpp)
* Benefit:
	* Just buy only u.fl to u.fl cable
		* Fanout board to CDCFE-Prototype(load, R/C)

### 2.4 Resistor layout of OPA2674

In the datasheet of [OPA2674](https://www.ti.com/lit/ds/symlink/opa2674.pdf), layout guide mentioned:
> Other network components, such as noninverting input
termination resistors, should also be placed close to the
package. Where double-side component mounting is allowed, **place the feedback resistor directly under the package on the other side of the board between the output and inverting input pins**. 

* 0402 resistor is good to fit layout
![](https://i.imgur.com/kf6vPA4.png)

###### tags: `Regular Meeting` `DeWei`