---
# System prepended metadata

title: Improve Beauty of Your Home By Installing French Door

---

# Improve Beauty of Your Home By Installing French Door

If talking about prehung door systems then these are door panels that have been assembled to a manufacturer’s frame and are built specifically for that [**Bifold door Mornington Peninsula**]([https:/](https://www.jcwindowsanddoors.com.au/door-replacements)/). Some contractors still believe that since a unit is prehung, it can be inserted into any aperture and instantly fastened to the structure. Each units should be plumb, level, & square. It can only be determined by following the installation guidelines, and skipping a step will result in erroneous operation as planned by the maker.
 
As a former warranty representative assessing Door installer in Mornington Peninsula all through the tri-state zone, I discovered that 8 out of 10 fitted units failed due to improper installation. Bad performance, damaged parts as a result of improper installation procedures, out of level components, arc thresholds, buckling panels, you name it. To ensure a proper installation, complete the instructions below or ensure that the installer follows them.
 
The old unit has been removed.
 
Examine the rough construction on the left and right levels (rack) as well as from front to back level; this will give you an idea of where and how you might want to arrange the new unit. When you recognize what framing circumstances exist before installing the door replacement in Mornington peninsula, you will understand where potential incompatibility with walls originates from.
 

 
Put a scale on the entryway floor threshold to see where the component frame has to be lifted or levelled. This is the most important factor to consider when installation; if you position the item on an uneven base, the next stages will not function properly. The work will be filmed. Because it’s rough carpentry, there is very often a 100% level.
 
Check for correct flashing of [**French doors Mornington Peninsula**](https://www.jcwindowsanddoors.com.au/door-replacements), which consists of a metal grid wrap from beneath the door to a “L” crouch down in front that will be hidden under the kicking plate below the new model threshold. Once installed, apply 100% silicone to the top to ensure that the new unit is fully sealed to avoid weather & wind from flowing under the doorway.
 
To temporarily wedges and hold the unit in place, position the unit and add left and right wooden dowel shims at the top head jam locations.
 
Start levelling the unit, checking the threshold and adding shimming where required, only under vertical jam stock, to lift that area of the unit to just provide level set.
Set to plumb & level by placing your level on the interior or outside of the jam on the left and right side.
 
Check if the Sliding doors Mornington Peninsula is level by placing your level on the jam frame’s left and right sides. This is the point at which a stacked unit can fail. A racked unit is merely out of plumb to the left or right. If you’ve ever encountered a door which rubs at the top frame, one portion of the strike jam hitting the door panel when shutting, or the sweep being pinched too tightly when closing, it could be due to a racked unit. Examine the other doors in your house.